To Read Boat Buyers Guide Click Here
This commercial boat comes standard with foam in the floor, rear bench, bow seat, 3 cleats on each gunnel rail, center console with steering, floor cable cover. You can also customize this boat to fit your work boat needs. This is the legal limit width wise for going down the road without a special permit.
Made to use a extra long shaft outboard, with your choice of either center console, side console or tiller control. Tiller with low horse power is recommended if not going long distances on water.
If using boat to haul dirt or other similar loads, a divider wall between storage area and driver area is recommended. Spud holes never hurt to hold boat still while loading or unloading. One per corner is probably best.
If loading such things as an excavator, we recommend spud holes in front corners to stabilize the boat for loading. Also no storage / extended deck so one can drive over bow into it.
Replacement plywood usage in floor will make floor last longer but adds weight. Foam in the floor will float boat, but not loaded boat, so be careful when loading, pay attention to water conditions, it determines maximum loaded capacity. One basically has 24" of vertical boat height, and draft at 10000lbs is approximately 12". If you want to hold more weight the boat will sink in the water approximately 1" for every 1000lbs.
Estimated Lead Time is 12 to 16 Weeks!